Whenever I have tried this, I get errors stating: component not found. Create netlist text file from connected copper. In addition, after nets are created via Netlist Manager, the trace that I manually drew lights up as an error as the actual trace itself is not assigned the net respective the pin it is connected too.Īlso, another method I have tried w/out success:ġ. So far this has shown to be an extremely time-consuming method of creating nets in a layout. So far, my only success in assigning nets has been to go into the netlist manager and creating nets manually and assigning them their respective pins. This board contains 375 nets, so I would very much like to use the DRC. The reason for this is that design rules are not enforced unless the trace/pin/component has been assigned a net. I have manually routed my board and I am trying to find a way to efficiently assign my traces/pins net names. I have an application where the schematic is dictated by the layout design.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |